Avocent ECMS2000U Uživatelská příručka stáhnout pdf (Strana 44)

38 Emerge Digital Extender System Installer/User Guide

To configure the network settings for the user station:

1. Press 1 to select the Receiver Network Config option in the Network Configuration Menu (in

either Extender or Desktop Mode).

2. Press Enter. The Receiver Network Configuration Menu will appear.

Figure 3.17: Receiver Network Configuration Menu (Extender and Desktop Mode)

NOTE: The Receiver Network Configuration Menu is identical in both Extender and Desktop modes.

NOTE: The reset option in the Receiver Network Configuration Menu applies only to network settings.

3. Press 1 to select the Receiver IP Address option and press Enter.

4. Type a valid IP address. Press Enter to return to the Receiver Network Configuration Menu.

5. Press 2 to select the Receiver Netmask option and press Enter.

6. Type a valid Receiver Netmask. Press Enter to return to the Receiver Network Configuration

Menu.

7. Press 3 to select the Receiver Default Gateway option and press Enter.

8. Type a valid Receiver Default Gateway. Press Enter to return to the Receiver Network

Configuration Menu.

9. Press 5 to select the Static/DHCP Network Configuration option to toggle between Static and

DHCP mode. Press Enter

10. Type 0 (zero) and press Enter to return to the Network Configuration Menu. If you made a

mistake and do not wish to save the changes you made to the network settings, type C and

press Enter.

NOTE: Changes to network configurations are applied only after you exit the Network Configuration Menu.

The ECMS user station will now automatically reset to apply the new network configuration.

During reset, the ECMS user station will drop its connection to the transmitter. You will be

returned to the Appliance Selection Menu screen. The connection will be restored.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 91 92

Žádné komentáře

Avocent ECMS2000U Uživatelská příručka Strana 44