Avocent ESP Multi-Interface Serial Hub SuperSerial Instalační příručka Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
10 Equinox ESP-2 MI Serial Hub Installation Guide
Creating OpenServer ESP Installation Diskettes on Windows
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
If you have autoplay enabled, the Equinox SuperSerial Software Installation screen
will appear.
If you do not have autoplay enabled, set your default drive to D: and run the
command
D:\SETUP, where D: is your CD-ROM drive letter.
2. Click UNIX on the Main Window.
3. Select the UNIX operating system for which you need drivers. Follow the on-screen
instructions for creating an installation diskette.
4. Once the OpenServer installation diskette is created, refer to the following le for
detailed installation instructions:
/drivers/esp/sco/readme.txt
UnixWare
The following sections contain procedures for installing the ESP driver on a UnixWare release
7.0.1a or higher system.
Creating UnixWare ESP Installation Diskettes on UnixWare
1. Mount the CD-ROM volume using the following command:
mount -f cdfs -0 fperm=0555,nmconv=c -r/dev/cdrom/c0b0t110/mnt
2. Run the following commands:
cd /mnt [or other mount point]
./makeunix.sh
3. Follow the on-screen instructions to build an installation diskette for UnixWare ESP.
4. Once the UnixWare installation diskette is created, refer to the following le for detailed
installation instructions: /drivers/esp/unixware/readme.txt
Creating UnixWare ESP Installation Diskettes on DOS
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
2. Set your default drive to the CD-ROM drive letter.
3. Run the command
MAKEUNIX and select the appropriate Equinox product and operating
system for which diskettes are needed.
4. Once the UnixWare installation diskette is created, refer to the following le for detailed
installation instructions: /drivers/esp/unixware/readme.txt
Creating UnixWare ESP Installation Diskettes on Windows
1. Load the Equinox SuperSerial Software CD in your CD-ROM drive.
If you have autoplay enabled, the Equinox SuperSerial Software Installation screen
will appear.
If you do not have autoplay enabled, set your default drive to D: and run the
command D:\SETUP, where D: is your CD-ROM drive letter.
2. Click UNIX on the Main Window.
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Komentáře k této Příručce

Žádné komentáře