Avocent AMX Switch Series Uživatelská příručka stáhnout pdf (Strana 53)

Chapter 4: Advanced Operations 43

To force a user to make or break a connection:

NOTE: The following rules apply for optimum operation of the force connection feature:

- Both the user entering the command and the user at the target user station must have rights to the server.

- All force connections are done in Shared mode.

- All user stations and AMIQ modules must have unique names.

- If the source and target user stations are connected to different AMX switches, the AMX switching system must

be synchronized using the AMWorks software.

1. Press the default Command Line hotkey sequence to display the Command Line.

2. Type fc ‘[TargetUserStationName]’ ‘[servername]’ and press Enter to force the target user

station to connect to the specified server.

3. Type fd ‘[TargetUserStationName]’ and press Enter to force the target user station to

disconnect from the connected server.

NOTE: The TargetUserStationName is shown in the OSCAR interface ? tab of the target user station. After

selecting the ? tab, press the

End key to view the unit name at the bottom of the tab. This unit name can be set

in the AMWorks software. The servername is the name of the AMIQ module and should be entered exactly as it

displays in the target list. Single quotes are required before and after the TargetUserStationName and the

servername. The following is an example of a force connection command: fc ‘User Station 3’ ‘Server 43’.

To configure the DDC table:

1. Press the default Command Line hotkey sequence to display the Command Line.

2. Type ddctable ‘[servername]’ default and press Enter to set the AMIQ module with the

specified servername to use the default DDC table.

3. Type ddctable ‘[servername]’ nVidia and press Enter to set the AMIQ module with the

specified servername to use the nVidia DDC table.

NOTE: The servername is the name of the AMIQ module and should be entered exactly as it displays in the

target list. Single quotes are required before and after the servername. The following is an example of the

command for a typical configuration DDC table: ddctable ‘Server 43’ nVidia.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 157 158

Žádné komentáře

Avocent AMX Switch Series Uživatelská příručka Strana 53